CJC-1295 is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Updated 2026-02-09. Numbers and descriptions here follow the published literature rather than marketing material.
Identity and purity are established with reversed phase high performance liquid chromatography coupled to mass spectrometry. The chromatographic step separates the target peptide from truncated sequences and deletion products, while the mass measurement confirms the expected molecular weight to within a fraction of a dalton. Because the two common variants differ by the presence of the linker, mass alone can distinguish them in the unconjugated state. Amino acid analysis and peptide mapping are used when sequence level confirmation is required.
Lyophilized material is generally stable for extended periods when held at minus twenty degrees Celsius or below and protected from moisture and light. In solution the peptide is more labile; bond hydrolysis, aggregation and oxidation of susceptible residues all proceed faster at ambient temperature. Repeated freeze and thaw cycles should be avoided because they promote clumping and loss of soluble material. The conjugated variant adds a further consideration, since the maleimide group can hydrolyze in aqueous buffer and lose its ability to react with albumin.
Laboratory handling centers on minimizing exposure to water, heat and oxygen before use. Working solutions are typically prepared in sterile water or a mild buffer, and any residual particulate matter is removed by filtration. When the powder dissolves slowly, a small proportion of acetonitrile or dilute acetic acid is sometimes added as a co-solvent. Containers are kept sealed and desiccated between uses. Records of lot number, reconstitution date and storage conditions support later comparison of results across experiments.
Characterization of this peptide relies on a small set of routine techniques. Reversed-phase high-performance liquid chromatography separates the target from truncated or oxidized by-products and yields a purity estimate when paired with ultraviolet detection near 214 nanometers. Mass spectrometry, either electrospray coupled to liquid chromatography or matrix-assisted laser desorption, confirms that the observed mass matches the value calculated for the expected sequence. Amino acid analysis, and enzymatic digestion followed by fragment mapping, are used when the sequence itself rather than the mass requires verification.
Stability depends heavily on physical state. A lyophilized powder kept dry, desiccated, and shielded from light typically holds its integrity for months to years at minus twenty degrees Celsius, and longer at minus eighty. Once dissolved, the peptide becomes far more vulnerable, since peptide bond hydrolysis, oxidation of susceptible residues, and aggregation all proceed faster in solution. Buffers near neutral pH are generally gentler than strongly acidic or alkaline conditions. Repeated freeze-thaw cycles and exposure to air-liquid interfaces during vigorous mixing cause losses that are easy to overlook.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off white powder | Typical lyophilized form |
| Water solubility | Soluble | May need a small organic co-solvent |
| Purity assessment | Chromatographic peak area | Most certificates report a percentage figure |
| Storage temperature | Minus 20 C or lower | Dry, dark, sealed container |
| Identity check | Electrospray mass spectrometry | Compared against theoretical mass |
Purity is most often assessed by reversed-phase high-performance liquid chromatography, reported as a percentage of total peak area. Identity is confirmed by mass spectrometry, which yields a molecular ion consistent with the expected sequence. Amino acid analysis and peptide mapping provide additional characterization. Reported purity values are method-dependent, so figures from different laboratories are not always directly comparable without details of column, gradient, and detection wavelength.
Peptide degradation proceeds mainly through hydrolysis, oxidation of methionine, and deamidation of asparagine or glutamine residues. The maleimide group on the albumin-binding variant can also react with thiols or hydrolyze in aqueous media. Because these pathways accelerate with temperature and pH extremes, handling conditions strongly influence measured stability. Stability data in the public literature are limited and often generated under differing conditions, so general statements about shelf life should be read as approximate.
Four amino acid substitutions separate the modified backbone from the parent GRF(1-29) sequence. These changes reduce recognition by dipeptidyl peptidase IV and related proteases, extending the interval before degradation. Development work in this area sought longer-acting GHRH analogs for endocrine investigation. Published descriptions treat the substitution set as a defining property of the core sequence, while the albumin-binding linker is described separately as an optional addition to that same backbone.
CJC-1295 is a synthetic peptide analog of growth hormone-releasing hormone, constructed on the 29-amino-acid fragment designated GRF(1-29). The name began as an internal development code during the 1990s and later spread through research supply catalogs and discussion forums. The molecule does not occur in nature; its sequence is engineered rather than isolated from tissue. Two related compounds are sold under this single label, and they differ by one appended chemical group that strongly influences how long the peptide remains in circulation.
The dividing feature between the two forms is a maleimide-based drug affinity complex, abbreviated DAC. In the DAC-bearing version, a linker attaches the peptide to serum albumin after administration, and that association slows removal from plasma. The version lacking DAC appears in catalogs as MOD GRF(1-29) or tetrasubstituted GRF(1-29). Because informal writing treats both as one item, comparisons drawn from such sources routinely blend measurements taken from two molecules with substantially different behavior.
Naming in this area is inconsistent, and readers should treat product labels with care. In much of the literature and in vendor catalogs, the unqualified term refers to the albumin-binding version, while the version lacking the DAC group appears as modified GRF(1-29), mod GRF(1-29), or the same name with a without-DAC qualifier. Because one abbreviation has been applied to both materials, the only reliable way to identify a sample is to check the stated sequence and the presence of the linker.
CJC-1295 is the name used for a synthetic peptide modeled on growth hormone-releasing hormone, the hypothalamic signal that prompts the pituitary to release growth hormone. The compound was described by a Canadian drug discovery company in the mid-2000s as a long-acting research tool. Two closely related molecules share the name in practice: one carries a drug affinity complex, or DAC, group, and one does not. The distinction matters because the two behave differently in circulation.
== Historical cases of contamination with diethylene glycol == On 4 May 2007, the FDA advised all U.S. makers of medicines to test all batches of glycerol for diethylene glycol contamination. This followed an occurrence of hundreds of fatal poisonings in Panama resulting from a falsified import customs declaration by Panamanian import/export firm Aduanas Javier de Gracia Express, S. A. The cheaper diethylene glycol was relabeled as the more expensive glycerol. Between 1990 and 1998, incidents of DEG poisoning reportedly occurred in Argentina, Bangladesh, India, and Nigeria, and resulted in hundreds of deaths. In 1937, more than one hundred people died in the United States after ingesting DEG-contaminated elixir sulfanilamide, a drug used to treat infections.
==== Liver injury ==== The prosecution argued that liver damage found at the post‑mortem of Child O could only be explained by deliberate harm, contrary to the original pathologist's view that the injury was natural. A senior perinatal pathologist who later reviewed the case said she had seen similar liver injuries arise naturally and described the prosecution expert's position as "naive". Published research documents hundreds of comparable cases occurring naturally in neonates. A joint report by two neonatologists working with Letby's legal team argued that the injury was worsened when a doctor accidentally punctured the liver by misplacing a needle. The prosecution pathologist and an independent expert interviewed by the BBC both said there was no evidence of needle trauma, although the BBC's expert also considered deliberate harm "unlikely". The Lee panel concluded that the doctor's needle may have penetrated the liver but considered it "highly likely" that the initial injury resulted from a traumatic delivery. They described the prosecution's blunt-force trauma hypothesis as "implausible". Neonatologist Mike Hall, who was instructed by Letby's first defence team but not called to testify, disputed the panel's traumatic‑delivery explanation but maintained that there was no evidence of deliberate harm.
=== Occurrence of lactobacillic acid === Following the discovery of lactobacillic acid in the lipids of Lactobacillus arabinosus, Klaus Hofmann's team was also able to determine this fatty acid in the lipids of Lactobacillus casei with a content of 16%. It is also present in L. acidophilus, L. buchneri, L. delbrueckii subsp. bulgaricus, L. delbrueckii subsp. lactis, L. fermentum and L. helveticus with a content of 10 to 30% has been detected. However, lactobacillic acid is not restricted to members of the genus Lactobacillus or lactic acid bacteria in general. The fatty acid was also found in higher proportions (10-20%) in gram-negative bacteria, such as Agrobacterium tumefaciens and Escherichia coli detected, in smaller quantities (5-10%) also in Serratia marcescens, Klebsiella aerogenes and Pseudomonas fluorescens. Brucellaspecies also contain lactobacillic acid, as well as Bordetella species, but the content here is only 1-2%. Lactobacillic acid is found in both Gram-positive and Gram-negative bacteria and is found in strictly aerobic, microaerophilic, facultative and strictly anaerobic genera. genera. Although the fatty acid is widely distributed in bacteria, it is not found in all genera. Bacteria that do not have unsaturated fatty acids in their membrane lipids do not have lactobacillic acid. This applies in particular to thermophilic bacteria and archaea. However, the fatty acid is found rather rarely in eukaryotic organisms. It is contained, for example, in rapeseed oil, which contains little erucic acid (so-called LEAR varieties).
Sources: en.wikipedia.org
=== Gas dissolving properties === Perfluorocarbons dissolve relatively high volumes of gases. The high solubility of gases is attributed to the weak intermolecular interactions in these fluorocarbon fluids. The table shows values for the mole fraction, x1, of nitrogen dissolved, calculated from the Blood–gas partition coefficient, at 298.15 K (25 °C), 0.101325 MPa.
=== Isotope effects === Isotope peaks within a spectrum can help in structure elucidation. Compounds containing halogens (especially chlorine and bromine) can produce very distinct isotope peaks. The mass spectrum of methylbromide has two prominent peaks of equal intensity at m/z 94 (M) and 96 (M+2) and then two more at 79 and 81 belonging to the bromine fragment. Even when compounds only contain elements with less intense isotope peaks (carbon or oxygen), the distribution of these peaks can be used to assign the spectrum to the correct compound. For example, two compounds with identical mass of 150 Da, C8H12N3+ and C9H10O2+, will have two different M+2 intensities which makes it possible to distinguish between them.
Additional inner doors reduce the loss of temperature when opening the main door. Icing within the ULT freezer should be reduced to a minimum. Modern ULT freezers employ variable speed drives for both the compressors and fans. This has reduced energy consumption a further 30% to typically 8.5 kWh/day.
=== January === The late 2000s recession has entered its second full year of existence. While many nations have managed to climb out of the recession, employment is still sparse and promises to remain so throughout 2010.
Sources: en.wikipedia.org
The consequence of using a single BB in couplings is the formation of a single compound in each bead. The formation of OBOC libraries is an inherent property of the S&P synthesis. The reason is explained in the figure. The structure of the compound formed in a bead depends on the reaction vessels in which the bead happens to occur in the synthetic route. It depends on the decision of the chemist to use the library in the tethered (OBOC) form or cleave down the compounds from the beads and use it as a solution.
=== Glycoprotein Ia / IIa complex (GPIa / IIa = integrin α2β1) === This is a receptor for collagen type I and IV. It consists of two subunits (α2 and β1). The α2 subunit includes a domain homologous to von Willebrand factor domain binding to collagen. The β1 subunit has four cysteine-rich regions and a structure similar to other β-integrins. The interaction with collagen leads to stabilization of the platelets. The surface expression of this complex shows high variability, particularly in relation to the polymorphism of GPIa subunit gene. Different opinions exist on the importance of C - T point mutation at position 807, which is believed to be associated with the risk of myocardial infarction or ischemic stroke.
Type 1 is Goodpasture syndrome, an autoimmune disease also affecting the lung. In Goodpasture syndrome, IgG antibodies directed against the glomerular basement membrane trigger an inflammatory reaction, causing a nephritic syndrome and the coughing up of blood. High dose immunosuppression is required (intravenous methylprednisolone) and cyclophosphamide, plus plasmapheresis. Immunohistochemistry staining of tissue specimens shows linear IgG deposits. Type 2 is characterised by immune-complex-mediated damage, and may be associated with systemic lupus erythematosus, post-infective glomerulonephritis, IgA nephropathy, and IgA vasculitis. Type 3 rapidly progressive glomerulonephritis, also called pauciimmune type, is associated with causes of vascular inflammation including granulomatosis with polyangiitis (GPA) and microscopic polyangiitis. No immune deposits can be seen on staining, however blood tests may be positive for the ANCA antibody. Histopathologically, the majority of glomeruli present "crescents". Formation of crescents is initiated by passage of fibrin into the Bowman space as a result of increased permeability of glomerular basement membrane. Fibrin stimulates the proliferation of endothelial cells of Bowman capsule, and an influx of monocytes. Rapid growing and fibrosis of crescents compresses the capillary loops and decreases the Bowman space, which leads to kidney failure within weeks or months.
Peach gum (also known as peach resin or peach tree gum) is a natural gum and resinous substance secreted by peach trees (Prunus persica) and related species in the Rosaceae family when the bark is damaged or the tree is stressed. It has a long history of consumption in China, where it is commonly used in sweet soups, desserts, and beverages. The substance is marketed for various health benefits, including claims about collagen content and skin improvement, though many of these claims lack scientific evidence.
=== Hypochondrogenesis === Hypochondrogenesis is caused by various COL2A1 mutations, including deletions, glycine substitutions, and truncations. These interfere with the formation of mature, triple-stranded type II collagen molecules, affecting collagen-rich tissues.
Sources: en.wikipedia.org
The mass difference from the linker is large enough for routine detection by mass spectrometry. The unconjugated form gives a single sharp signal at its expected weight. Material that has already reacted with albumin shows a much higher mass and a broadened chromatographic peak.
Yes. Degradation proceeds faster once the powder is dissolved, especially at room temperature or after multiple freeze and thaw cycles. Working solutions are often aliquoted to avoid repeated handling. Lyophilized powder held cold and dry retains its properties far longer.
Truncated sequences, oxidized residues and aggregated forms can all elute near the main peak. Reversed phase chromatography resolves many of these species, so the number of peaks is a useful indicator of synthesis quality. A single peak does not by itself prove correct sequence, which is why mass confirmation is paired with it.
Mass spectrometry establishes whether the observed molecular weight matches the calculated sequence mass. Chromatographic retention and fragment mapping add further confidence about sequence and composition. A single technique alone is rarely treated as sufficient evidence of identity.