This is a working overview of DAC, written for readers who want more than a one-paragraph summary but less than a textbook.
This page was last updated on 2026-07-05 and is reviewed periodically as new material appears.
Verification matters because research peptides vary widely in quality. A certificate of analysis is only as reliable as the method behind it, and a single chromatographic trace reveals little about counter-ions, residual solvents, or water content. Independent laboratories commonly pair mass confirmation with chromatographic purity and, where relevant, quantify water along with acetate or trifluoroacetate content. Reported purity figures are not standardized across suppliers, so a stated value such as ninety-eight percent is not directly comparable unless the analytical method, column, and detection wavelength accompany it.
Characterization of this peptide relies on a small set of routine techniques. Reversed-phase high-performance liquid chromatography separates the target from truncated or oxidized by-products and yields a purity estimate when paired with ultraviolet detection near 214 nanometers. Mass spectrometry, either electrospray coupled to liquid chromatography or matrix-assisted laser desorption, confirms that the observed mass matches the value calculated for the expected sequence. Amino acid analysis, and enzymatic digestion followed by fragment mapping, are used when the sequence itself rather than the mass requires verification.
Stability depends heavily on physical state. A lyophilized powder kept dry, desiccated, and shielded from light typically holds its integrity for months to years at minus twenty degrees Celsius, and longer at minus eighty. Once dissolved, the peptide becomes far more vulnerable, since peptide bond hydrolysis, oxidation of susceptible residues, and aggregation all proceed faster in solution. Buffers near neutral pH are generally gentler than strongly acidic or alkaline conditions. Repeated freeze-thaw cycles and exposure to air-liquid interfaces during vigorous mixing cause losses that are easy to overlook.
Lyophilized material is generally stable for extended periods when held at minus twenty degrees Celsius or below and protected from moisture and light. In solution the peptide is more labile; bond hydrolysis, aggregation and oxidation of susceptible residues all proceed faster at ambient temperature. Repeated freeze and thaw cycles should be avoided because they promote clumping and loss of soluble material. The conjugated variant adds a further consideration, since the maleimide group can hydrolyze in aqueous buffer and lose its ability to react with albumin.
Laboratory handling centers on minimizing exposure to water, heat and oxygen before use. Working solutions are typically prepared in sterile water or a mild buffer, and any residual particulate matter is removed by filtration. When the powder dissolves slowly, a small proportion of acetonitrile or dilute acetic acid is sometimes added as a co-solvent. Containers are kept sealed and desiccated between uses. Records of lot number, reconstitution date and storage conditions support later comparison of results across experiments.
Identity and purity are established with reversed phase high performance liquid chromatography coupled to mass spectrometry. The chromatographic step separates the target peptide from truncated sequences and deletion products, while the mass measurement confirms the expected molecular weight to within a fraction of a dalton. Because the two common variants differ by the presence of the linker, mass alone can distinguish them in the unconjugated state. Amino acid analysis and peptide mapping are used when sequence level confirmation is required.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Assessed by visual inspection under ordinary light |
| Primary analytical method | Reversed-phase liquid chromatography | Purity estimated from peak area at 214 nm |
| Confirmatory method | Mass spectrometry | Observed mass compared with calculated value |
| Powder storage temperature | Minus 20 degrees Celsius | Minus 80 for extended archival periods |
| Solution stability | Hours to days at 2 to 8 degrees Celsius | Influenced by pH, buffer, and concentration |
CJC-1295 is the name used for a synthetic peptide modeled on growth hormone-releasing hormone, the hypothalamic signal that prompts the pituitary to release growth hormone. The compound was described by a Canadian drug discovery company in the mid-2000s as a long-acting research tool. Two closely related molecules share the name in practice: one carries a drug affinity complex, or DAC, group, and one does not. The distinction matters because the two behave differently in circulation.
The peptide backbone corresponds to GRF(1-29), the first 29 residues of native growth hormone-releasing hormone, which retains most of the receptor-activating activity of the full-length molecule. Four substitutions distinguish the analog from the natural sequence: D-alanine at position 2, glutamine at position 8, alanine at position 15, and leucine at position 27. These changes slow cleavage by dipeptidyl peptidase IV, the enzyme that degrades native hormone in plasma within minutes. The outcome is improved enzymatic stability combined with a still brief residence time when no additional modification is present.
CJC-1295 is a synthetic peptide analog of growth hormone-releasing hormone, constructed on the 29-amino-acid fragment designated GRF(1-29). The name began as an internal development code during the 1990s and later spread through research supply catalogs and discussion forums. The molecule does not occur in nature; its sequence is engineered rather than isolated from tissue. Two related compounds are sold under this single label, and they differ by one appended chemical group that strongly influences how long the peptide remains in circulation.
The dividing feature between the two forms is a maleimide-based drug affinity complex, abbreviated DAC. In the DAC-bearing version, a linker attaches the peptide to serum albumin after administration, and that association slows removal from plasma. The version lacking DAC appears in catalogs as MOD GRF(1-29) or tetrasubstituted GRF(1-29). Because informal writing treats both as one item, comparisons drawn from such sources routinely blend measurements taken from two molecules with substantially different behavior.
Four amino acid substitutions separate the modified backbone from the parent GRF(1-29) sequence. These changes reduce recognition by dipeptidyl peptidase IV and related proteases, extending the interval before degradation. Development work in this area sought longer-acting GHRH analogs for endocrine investigation. Published descriptions treat the substitution set as a defining property of the core sequence, while the albumin-binding linker is described separately as an optional addition to that same backbone.
Peptide degradation proceeds mainly through hydrolysis, oxidation of methionine, and deamidation of asparagine or glutamine residues. The maleimide group on the albumin-binding variant can also react with thiols or hydrolyze in aqueous media. Because these pathways accelerate with temperature and pH extremes, handling conditions strongly influence measured stability. Stability data in the public literature are limited and often generated under differing conditions, so general statements about shelf life should be read as approximate.
Research material is normally supplied as a freeze-dried powder in sealed vials. In that state the peptide is comparatively robust, but prolonged exposure to warmth, moisture, or light accelerates degradation. Storage at minus twenty degrees Celsius or lower, with desiccant and protection from light, is the commonly described practice. Vials should be allowed to reach room temperature before opening to limit condensation on the powder. Moisture uptake during handling is a recognized source of variability in later measurements.
== Labeling methods == Proteins can be biotinylated chemically or enzymatically. Chemical biotinylation utilises various conjugation chemistries to yield nonspecific biotinylation of amines, carboxylates, sulfhydryls and carbohydrates (e.g., NHS-coupling gives biotinylation of any primary amines in the protein). Enzymatic biotinylation results in biotinylation of a specific lysine within a certain sequence by a bacterial biotin ligase. Most chemical biotinylation reagents consist of a reactive group attached via a linker to the valeric acid side chain of biotin. As the biotin binding pocket in avidin / streptavidin is buried beneath the protein surface, biotinylation reagents possessing a longer linker are desirable, as they enable the biotin molecule, once it has been attached to its target, to be more accessible to binding avidin/streptavidin/Neutravidin protein. This linker can also mediate the solubility of biotinylation reagents; linkers that incorporate poly(ethylene) glycol (PEG) can make water-insoluble reagents soluble or increase the solubility of biotinylation reagents that are already soluble to some extent.
Deoxyribonucleic acid (; DNA) is a polymer composed of two polynucleotide chains that coil around each other to form a double helix. The polymer carries genetic instructions for the development, functioning, growth and reproduction of all known organisms and many viruses. DNA and ribonucleic acid (RNA) are nucleic acids. Alongside proteins, lipids and complex carbohydrates (polysaccharides), nucleic acids are one of the four major types of macromolecules that are essential for all known forms of life. The two DNA strands are known as polynucleotides as they are composed of simpler monomeric units called nucleotides. Each nucleotide is composed of one of four nitrogen-containing nucleobases (cytosine [C], guanine [G], adenine [A] or thymine [T]), a sugar called deoxyribose, and a phosphate group. The nucleotides are joined to one another in a chain by covalent bonds (known as the phosphodiester linkage) between the sugar of one nucleotide and the phosphate of the next, resulting in an alternating sugar-phosphate backbone. The nitrogenous bases of the two separate polynucleotide strands are bound together, according to base pairing rules (A with T and C with G), with hydrogen bonds to make double-stranded DNA. The complementary nitrogenous bases are divided into two groups, the single-ringed pyrimidines and the double-ringed purines. In DNA, the pyrimidines are thymine and cytosine; the purines are adenine and guanine. Both strands of double-stranded DNA store the same biological information. This information is replicated when the two strands separate.
Ever since the discovery that monoclonal antibodies could be generated, scientists have targeted the creation of fully human products to reduce the side effects of humanised or chimeric antibodies. Several successful approaches have been proposed: transgenic mice, phage display and single B cell cloning.
A plant morphologist makes comparisons between structures in many different plants of the same or different species. Making such comparisons between similar structures in different plants tackles the question of why the structures are similar. It is quite likely that similar underlying causes of genetics, physiology, or response to the environment have led to this similarity in appearance. The result of scientific investigation into these causes can lead to one of two insights into the underlying biology:
Sources: en.wikipedia.org
Faced with possibility of ongoing player boycotts – including a potential boycott of the following month's Brownlow Medal count, which was televised by Seven – the Seven Network issued a statement regretting any harm the broadcast may have caused to the AFL, the clubs and the players, and promised not to broadcast or reveal any of the details of the medical records in future. The AFLPA, which had previously demanded an apology from the network over the incident, said that it understood why Seven could never issue a full apology "for legal reasons" and that it would be taking the "statement of regret" as an apology instead. The player boycott has since been lifted. The woman who found the medical records and a male accomplice were charged with "theft-by-finding" and faced Heidelberg Magistrates' Court on 6 December 2007. They subsequently pleaded guilty and were sentenced to a 12-month good behaviour bond and ordered to pay the money they received from Channel 7 into a court fund.
=== Protein stabilization for optimized isolation === Thermofluor pre-screens can be performed that sample a wide range of pH, ionic strength, and additives such as added metal ions and cofactors. The generation of a protein response surface is useful for establishing optimal assay conditions and can frequently lead to improved purification scheme as required to support HTS campaigns and biophysical studies.
== Epidemiology == Diseases caused by P. syringae tend to be favoured by wet, cool conditions—optimum temperatures for disease tend to be around 12–25 °C (54–77 °F), although this can vary according to the pathovar involved. The bacteria tend to be seed-borne, and are dispersed between plants by rain splash. Although it is a plant pathogen, it can also live as a saprotroph in the phyllosphere when conditions are not favourable for disease. Some saprotrophic strains of P. syringae have been used as biocontrol agents against postharvest rots.
Sources: en.wikipedia.org
Mass spectrometry establishes whether the observed molecular weight matches the calculated sequence mass. Chromatographic retention and fragment mapping add further confidence about sequence and composition. A single technique alone is rarely treated as sufficient evidence of identity.
Dry powder is markedly more stable than solution and is usually held frozen and desiccated. Room temperature exposure over days degrades it more slowly than most people assume, but long-term integrity favors freezer storage. Light protection is recommended regardless of temperature.
Methods, columns, gradients, and detection wavelengths are not standardized across laboratories. Some figures describe only the main peak area at one wavelength and ignore water, salts, or counter-ions. Without stated conditions, comparing reported percentages across sources is unreliable.
The mass difference from the linker is large enough for routine detection by mass spectrometry. The unconjugated form gives a single sharp signal at its expected weight. Material that has already reacted with albumin shows a much higher mass and a broadened chromatographic peak.